SCUBA Outlets

Thermo scuba valves come with three different outlets to mate with any of the most common scuba regulators.  The choice of which outlet to use is based on cylinder pressure and desired flexibility.  the Thermo K and Thermo PRO scuba outlets are designed for cylinders with service pressures up to 230 Bar and the Thermo DIN scuba outlet is designed for cylinders with service pressures above 230 Bar.

(Click on any picture below for a larger view)

THERMO K TYPE OUTLET

The outlet on the Thermo K valve is designed with twin dimples in the bottom section of the o-ring keeper.  This helps to avoid o-ring blowout when disconnecting your first stage regulator. The K type outlet is used on valves with service pressures up to 230 Bar.

THERMO PRO TYPE OUTLET

The outlet on the Thermo PRO valve comes with a removable insert which allows the valve to be used either as a K type yoke outlet or as a 230 Bar threaded DIN outlet.  Whether your regulator has a K type yoke connection, 230 Bar DIN connection or 300 Bar DIN connection, it will attach to the Thermo PRO valve.  This type of outlet gives you the maximum amount of versatility on cylinders with pressures up to 230 Bar.  

THERMO DIN TYPE OUTLET

The outlet on the Thermo DIN series of valves is designed for higher pressure cylinders.  This outlet can be found on valves for use at pressures up to 3500 or 4350 psi.  This outlet is primarily used on cylinders with service pressures above 230 Bar.  The additional threads in the Thermo DIN outlet will not allow either K type regulators or 230 Bar type regulators to attach to it in order to protect down stream equipment from higher pressures.

See NEWS for announcement that XS Scuba has acquired the exclusive rights to manufacture and distribute Thermo Scuba Valves!